When you surpass the next planned oil change interval, the oil change required light will set out on the display. The indicator should be reset after you carry out the required maintenance on your Jeep. Depending on the vehicle model you have, there are few ways of resetting the oil life, as explained below.
Model 2012, 2013, 2014, 2015, 2016, 2018, 2020
- If new to the procedure, first check the owner’s manual.
- Startup ignition, but let the engine remain off.
- Step on the throttle gradually three times in 10 seconds.
- Later turn the ignition switch to the off position.
- Switch on the machine to confirm if the indicator is set.
After the procedure, the monitor will reset in intervals. If the maintenance light remains lit, you did the procedure wrong; consider repeating.
2017 Model and 2019
The vehicle can apply two methods to reset oil life on a jeep wrangler. The first method follows the exact procedure for model 2012- 2016. The other process is as follows;
- First, switch on ignition to the run position and don’t turn on the motor. Next, push the button to start the ignition, then press it twice to enter a run position.
- Use the steering wheel buttons to find the vehicle information on your display and select oil life.
- Depress the ok button and hold it until the jeep wrangler oil life percentage gets to 100.
- Switch the ignition off and start the engine to confirm if the indicator has been reset.
Check this too: What Happens if You Use 5W20 in a 5W30 Car?
Conclusion
That’s the procedure for resetting oil life on a jeep wrangler. The processes are straightforward if you don’t know how to reset. However, it’s best if you carry out the resetting when changing the oil in your Jeep.